Sanyo C4272R S/C - Manual (Page 39)

39
K
3-13. Remove the Grille to Install the Indoor Unit
Basically, these models can be installed and wired
without removing the grille. If access to any internal
part is needed, follow the steps given below:
How to remove the grille
(1) Set the 2 flaps in the horizontal position.
(2) Unscrew the 3 screws. (Fig. 3-40a)
(3) Remove the grille.
(a) Hold both corners of the air intake grille, then
pull out and up to open. (Fig. 3-40b)
(b) Use a standard screwdriver to push up the 3
tabs to remove the grille. (Fig. 3-40b)
(c) Pull the lower part of the grille toward you to
remove. (Fig. 3-40a)
How to replace the grille
(1) Close the flaps.
(2) Reinstall the grille into the lower part while aligning
its tabs on the upper part. (Fig. 3-41a) Insert the
tabs in the slots and push the lower part of the
grille back into position.
(3) Press at each of the 5 tabs to completely close the
grille. Make sure that the grille and frame are firmly
fitted together. (Fig. 3-41b)
KH(S)2672R Air-intake grille
Grille
Fig. 3-40a
Air-intake grille
Fig. 3-40b
Fig. 3-41a
Fig. 3-41b
07-115 SSHP_II 5/7/07 3:59 PM Page 39