Sanyo C4272R S/C - Manual (Page 68)

68
RC
(WL)
When using this air conditioner with the wireless
remote controller it may sometimes be
impossible to change the operation modes while
other indoor unit is running.
When this happens, a double beep tone sounds,
the (operation lamp) lights up, and the (Timer
lamp) and (Standby lamp) blink alternately.
Operation is the same even during (AUTO mode)
automatic cooling or heating.
A beep tone sounds 5 times and no changes can
be made when any of the ON/OFF, MODE, Tem-
perature setting buttons were pressed while set
under central control by the system controller.
7-1. Wireless Remote Controller Installation
The remote controller can be operated from either a
non-fixed position or a wall-mounted position.
To ensure that the air conditioner operates correctly,
do not install the remote controller in the following
places:
In direct sunlight.
Behind a curtain or other place where it is covered.
More than 26 ft. away from the air conditioner.
In the path of the air conditioner’s airstream.
Where it may become extremely hot or cold.
Where it may be subject to electrical or magnetic
interference.
(1) If Wall-mounted Fixed Position
Install the remote controller at a convenient
location on a nearby wall. However, before
attaching the remote controller mounting cradle,
check that the remote controller can operate from
the desired wall position. (Fig. 7-1)
How to Install Batteries
See Fig. 7-2.
(1) Press and slide the lid on the back of the remote
controller in the direction of the arrow.
(2) Install two AAA alkaline batteries. Make sure the
batteries point in the direction marked in the
battery compartment.
(3) Press the ACL button, then replace the lid. If you
press it, the current time, ON time, and OFF time
are all reset to 0:00.
Fig. 7-2
Fig. 7-1
Mounting cradle
Put on
1
2
Push
Screws for fixture
Truss-head
tapping screws
(4
× L5/8")
ACL button
Cover
IMPORTANT
7. HOW TO INSTALL THE WIRELESS REMOTE CONTROLLER
(ACCESSORY PART / OPTIONAL PART)
07-115 SSHP_II 5/7/07 4:00 PM Page 68