Sanyo C4272R S/C User Manual
Page 92
SC
92
(b)
Zone registration using the system controller
(SHA-KC64UG)
In this case, you set all central addresses by
the system controller at once manually.
(1)
Press the
and
ZONE
buttons at the same
time for more than 4 seconds.
and CODE No. C1 will flash.
(2)
After confirming that CODE No. C1 is displayed,
press the
button. Once in this mode, a
change takes place as shown in Fig. 8-8.
(3)
Select the zone and group No. you want to
set with
ZONE
and
(GROUP)
buttons.
If already set, press the
buttons.
(4)
Set the unit No. (indoor unit address) with
and
buttons, according to the zone registra-
tion table.
R.C. No. ...................
button
Indoor unit No. ..........
button
(5)
Press the
button.
GROUP No. turns ON and UNIT No. (indoor unit
address) changes from flashing to ON state.
UNIT No. is registered to the selected ZONE No.
and GROUP No.
If you make a mistake, press the
button
and reselect the ZONE, GROUP and UNIT No.
(6)
Register the other UNIT Nos. in the same way by
following steps (3) to (5).
(7)
Finally, complete the registration by pressing the
button.
flashes for a few minutes, then turns OFF.
For example, in this case
Zone 3, Group No. 7
Unit No. (indoor unit address) 2-8
Unit No. 2-8 is registered to Zone 3, Group 7.
Fig. 8-9
Fig. 8-8
ZONE
ZONE
1
ZONE
SELECT
GROUP
9
2
3
4
6
Selected group
No. if no data is
registered.
If no data is
registered
no number is
displayed.
If data is
registered
the unit No.
is displayed.
ZONE
ZONE
1
ZONE
SELECT
GROUP
9
2
3
4
7
6
07-115 SSHP_II 5/7/07 4:00 PM Page 92