National Instruments NI-Motion - Manual (Page 172)

Chapter 12 Synchronization
NI-Motion User Manual 12-22 ni.com
Figure 12-11. Breakpoint Modulus of 500
As another example, if you set the breakpoint repeat period to be 2000
counts and the offset to be –500, breakpoints occur at –4500, –2500, –500,
1500, 3500. If the breakpoint is enabled when the axis is at 2210, the
breakpoints at 1500 and 3500 are both armed, as shown in Figure 12-12.
Figure 12-12. Breakpoint Modulus of 2000 with an Offset of 500
Each time a breakpoint occurs, re-enable it to load the next breakpoint.
0 –500 –1000 1000 500
= Breakpoint
= Armed Breakpoint
= Current Position
0 –2000 –4000
–4500 –2500 –500 1500 3500
4000 2000
= Breakpoint
= Armed Breakpoint
= Current Position