Ricoh Aficio MP 6000 - Manual (Page 143)

Initial Settings
133
4
❖ SIP Settings
Set the SIP server's IPv4 address or host name, and SIP user name.
If you select [On] using the User Parameters, you can use the SIP server. See
“Parameter Settings” ( switch 34, bit 1).
You can use alphanumeric symbols (lower and upper cases) and symbols (“;”,
“?”, “:”, “&”, “=”, “+”, “$”, “,”, “-”, “_”, “.”, “!”, “~”, “*”, “#”, “‘”, “(”, “)”, “%”,
“/”, and “@”) for registration of the SIP User Name in SIP Settings. Make sure
you enter these characters correctly.
Use numbers and periods (“.”) to enter the correct IPv4 addresses for the gate-
keeper, SIP server, and gateway. To obtain the correct IPv4 addresses, consult
the administrator.
A Press [Facsimile Features].
B Press [Initial Settings].
C Press [SIP Settings].
D Press [Change] for each property.
A proxy server relays call requests and responses.
A redirect server processes request destination inquiries.
A register server registers location information of user agents (which cor-
respond to telephones or facsimiles on public telephone lines) on an IP net-
work.
E Enter the IPv4 address or host name, and SIP user name, and then press
[OK]
.
F Specify whether to perform SIP digest authentication.
If you select [On], enter the password using up to 128 characters.
G Press [OK].
❖ Program / Change / Delete Gateway
Register, change, or delete the gateway used for transmission to IP-Fax.
• Program / Change
A Press [Facsimile Features].
B Press [Initial Settings].
C Press [Program / Change / Delete Gateway].
D Check that [Program / Change] is selected.
E Press a gateway to register.
When registering a new gateway, press [Not Programmed].