Ricoh Aficio MP 6000 - Manual (Page 16)

Connecting the Machine
6
1
Connecting to the Ethernet Interface
This section describes how to connect 10BASE-T or 100BASE-TX cable to the Eth-
ernet interface.
Important
❒ If the main power switch is turned “On”, turn it “Off”.
A
A ferrite core for the Ethernet cable is supplied with this machine. The Eth-
ernet cable loop should be about 15 cm (5.9 inch) (
) from the machine end
of the cable.
B
Make sure the main power switch on the machine is “Off”.
C
Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.
D
Connect the other end of the Ethernet cable to a network connection device
such as a hub.
AEV047S
BEY003S