Settings required to use scan to folder function, Ethernet – Ricoh Aficio MP 6000 User Manual
Page 31
Network Settings
21
1
Note
❒ As to [Effective Protocol], check if the protocol to use is set as [Active].
❒ [LAN Type] is displayed when optional wireless LAN interface board is in-
stalled. If both ethernet and wireless LAN (IEEE 802.11b) are connected, the
selected interface takes precedence.
❒ When setting [POP before SMTP] to [On], also make setting for [Reception Proto-
col]
and [POP3 / IMAP4 Settings].
❒ When setting [POP before SMTP] to [On], check [POP3] port number in [E-mail
Communication Port]
.
Reference
p.49 “Interface Settings”
p.56 “File Transfer”
Settings Required to Use Scan to Folder Function
This section lists the settings required for sending files.
Ethernet
This section lists the settings required for sending files with an Ethernet connec-
tion.
For details about specifying the settings, see “Interface Settings” and “File
Transfer”.
Heading
Setting Item
Setting Requirements
Interface Settings/Network Machine IPv4 Address
Necessary
Interface Settings/Network IPv4 Gateway Address
Necessary
Interface Settings/Network DNS Configuration
As required
Interface Settings/Network DDNS Configuration
As required
Interface Settings/Network Domain Name
As required
Interface Settings/Network WINS Configuration
As required
Interface Settings/Network Effective Protocol
Necessary
Interface Settings/Network Ethernet Speed
As required
Interface Settings/Network LAN Type
Necessary
Interface Settings/Network Permit SNMPv3 Communication
As required
Interface Settings/Network Permit SSL / TLS Communication
As required
Interface Settings/Network Host Name
As required
File Transfer
Scanner Resend Interval Time
As required
File Transfer
Number of Scanner Resends
As required