Oracle Audio Technologies ORACLE9I B10508-01 - Manual (Page 63)

Setup Tasks for Oracle Products
CD-ROM Pre-installation Requirements 3-19
Set Display
Before starting the Oracle Universal Installer, set your display appropriately. Enter:
$ SET DISPLAY/CREATE/TRANSPORT=TCPIP/NODE=< workstation_name or IP_address >
and verify that it is correct by using the following command:
$ RUN SYS$SYSTEM:DECW$CLOCK
Refer to each logical entry in this section for instructions on setting the logical
correctly.
Do not use the hostname or IP address of the system where the software is being
installed unless you are performing the installation from the X-Windows console
of
that system. Use the machine name or IP address of your own workstation if you
are installing from a remote system . If you are not sure of the X server and screen
settings, then use 0 (zero) for both.
Setup Tasks for Oracle Products
The following products require pre-installation steps to be completed before you
install Oracle9i software:
■
Precompilers and Tools
■
Network and System Management Products
Precompilers and Tools
Complete pre-installation tasks for the precompilers and tools that are required for
hp OpenVMS Alpha.
Pro*COBOL Restriction
The use of incorrectly aligned binary data (such as COMP-1 ) in Pro*COBOL
applications will generate unaligned access warnings that will prevent optimum
compiler performance, but will not affect the application results.
Note: If an Oracle server already exists on your system, then its
settings may have a bearing on the settings that you choose for the
new environment.