Zhone Technologies 900 - Manual (Page 121)

Data Cards IMACS System Release 5.1.6 5-7
BRI Card BRI Card User Screens and Settings
Table 5-2. BRI U*8 and BRI-SC U*8 Card Configuration Option Settings and Defaults
Notes:
1. D-Channels will only show if brite is selected for Type.
2. These options are only available for LB GEN Modes of ddsT and ddsN. See LB GEN
paragraph below.
3. The Sealing Current option setting for the BRI-U*8 (826070) card is n/a and for the
BRI-SC U*8 (826171) card are off and on.
5.3.2 BRI-SC U*8 Sealing Current
This screen applies to the BRI-SC U*8 card only, and only in LT mode. Move the cursor to
the SEAL CURR selection for the desired channel and press <Enter> to bring up the screen in
Figure 5-5.
Parameter User Options Notes Default
STATE stdby actv stdby
TERMINAL lt nt lt
TYPE lease brite ntu-l lease
B MODE none B1 B2 B1+B2 128K none
B1 WAN/SRV none w1-1 w1-2 w2-1 w2-2 w3-1 w3-2 w4-1
w4-2 P1 P2 P3 none
B1 TS n/a 01-24 01-31 n/a
B2 WAN/SRV none w1-1 w1-2 w2-1 w2-2 w3-1 w3-2 w4-1
w4-2 P1 P2 P3 none
B2 TS n/a 01 to 24 01 to 31 n/a
D WAN/SRV n/a w1-1 w1-2 w2-1 w2-2 w3-1 w3-2 w4-1
w4-2 1 n/a
D TS n/a 01 to 24 01 to 31 1 n/a
D SUBCHAN n/a off 1 2 3 4 1 n/a
LOCAL LB off ta net off
LB CHAN B1 B2 B1+B2 B1
LBGEN MD ddsT ddsN v54T v54N ft1T ft1N eoc ddsT
LB GEN off B1ocu B1csu B1ds0 B1dsu B2ocu B2csu
B2ds0 B2dsu 2 off
SEAL CURR n/a off on 3 n/a
TR COND n/a n/a