Zhone Technologies 900 - Manual (Page 57)

Data Cards IMACS System Release 5.1.6 1-45
HSU Card HSU Card User Screens and Settings
The information presented in this section is listed in the RS366 dialing matrix shown in Table
1-19.
Note: In order to make use of the loopback management feature, your DTE must support the
generate call command while connected and in use.
1.3.14 Call Profile Changes
Another application for RS366 dialing is modifying call profile parameters that cannot be
changed by the Basic Dialing commands. The system uses this application for making changes
to all of the fields in the call profiles embedded in the system. A different command string is
used to make these changes.
The command string is: [escape character] [64] [parameter number] [parameter value] where
the parameters are found on the call profile screen of the Interface card.
Table 1-18 shows the Call Profile parameter name, parameter number and parameter value to
be used with this command.
Table 1-18. MUX Call Screen Actions
If the IMUX Call is yes, the selection for Channel Rate will be 01=56, 02=64 and 03=H0. If
the IMUX Call is used, the selections for Rate Multiplier will be 02-30 for 56/64 and 2-3 for
H0.
1.3.14.1 Example
The command, *64122, sets the current value of Present. Indctr to no.
73 Loopback #3 enable (i.e. remote network loopback)
Parameter
Name
Parameter
Number
Parameter Value
DChan 01 a number from 01-08
Called # 02 4 through 25 numeric characters can be entered
Called # Type 03 01=natnl, 02=intnl, 03=sbscr
Called # Plan 04 01=unkwn, 02=isdn, 03=phone, 04=print
Channel Rate 05 01=56u, 02=56r, 03=64u, 04=64r, 05=364u, 06=364r, 07=1536r, 09=MRate
Rate Multiplier 06 02-24 (only available if MRate is chosen)
IMUX Call 07 01=no, 02=yes
Service 08 01=first billing plan, 02=second billing plan, etc.
Calling # 09 4 through 25 numeric characters can be entered
Calling # Type 10 01=natnl, 02=intnl, 03=sbscr
Calling # Plan 11 01=unkwn, 02=isdn, 03=phone, 04=print
Present. Indctr 12 01=yes, 02=no
Screen. Indctr 13 01=up-ns