Bri card bri card user screens and settings – Zhone Technologies 900 User Manual
Page 149
Data Cards
IMACS System Release 5.1.6
5-35
BRI Card
BRI Card User Screens and Settings
ALARM
This parameter indicates whether or not any active alarms exist. The options are none
(default), U (U interface is down), L (NTU has lost sync and is not yet configured), R (NTU
has been reset and is not yet configured), and M (NTU is in the Master mode). This option is
not user-selectable.
CTS
This field indicates the control signal status for this parameter. The options are off and on. This
option is not user-selectable.
DSR
This field indicates the control signal status for this parameter. The options are off and on. This
option is not user-selectable.
DCD
This field indicates the control signal status for this parameter. The options are off and on. This
option is not user-selectable.
RTS
This field indicates the control signal status for this parameter. The options are off and on. This
option is not user-selectable.
DTR
This field indicates the control signal status for this parameter. The options are off and on. This
option is not user-selectable.
DTR
off on
---
RX FIFO ERR
yes no
no
TX FIFO ERR
yes no
no
HW CODE
0 to 255
---
LINE TR
tp3410 st5411
---
ASIC REV
0 to 255
---
EPLD REV
0 to 255
---