Zhone Technologies 900 - Manual (Page 26)

1-14 IMACS System Release 5.1.6 Data Cards
Model No. Running Head HSU Card User Screens and Settings HSU Card
Table 1-5. HSU Card Setting Options and Defaults
Notes:
1. The WAN/SRV parameter has three optional choices: wan, serv and user. In wan
mode, the options are w1-1 through w4-2. In serv mode, the option are P1-P3 and in
user mode, the options are U1-U8 (Port 1-4).
2. If the WAN selected above has a CSU or DSX module connected, the values range from
1-24. If a CEPT module is installed the values are 1-31.
3. These options are only valid if the Loopback Generation Mode selected is dds. If the
Loopback Generation Mode is v.54 or ft1, then the LB GEN options are off and on.
4. This is an information-only field, there are no user selections.
5. DTE mode is only for HSU-T (8203, 8214).
6. Displays only for HSU-AD 530/35 (8213).
7. Displays only for HSU*4E 530/35 (8216). For other models the parameter will display
CLOCK PLRTY.
Parameter User Options Notes Default
STATE stdby actv stdby
WAN/SRV wan serv user 1 w1-1
MODE dce dte 5 dce
TS table 2 table
RATE 64k 56k 56k
TX CLOCK int ext int
Tx CLOCK PLRTY norm inv 7 norm
DATA PLRTY norm inv norm
CTS perm rlocal ignor local perm
CTS DELAY 0 30 60 100 0
LOCAL LB off dte net off
LB GEN MODE dds v.54 ft1 dds
LB GEN off ocu csu (csu-1, csu-2) dsu ds0 (ds0-1, ds0-2) 3 off
LB DET w/to on off w/to
ISDN CONN no 4 no
EER off on none 10e
-4
- 10e
-9
6 none
Rx CLOCK PLRTY norm inv 7 norm