Zhone Technologies 900 - Manual (Page 58)

1-46 IMACS System Release 5.1.6 Data Cards
Model No. Running Head HSU Card User Screens and Settings HSU Card
The command, *640303, sets the Called Number TYpe to sbscr. Call Profile changes
permanently alert the active call profile for this HSU port.
The information presented in this section is listed in the RS366 dialing matrix shown in Table
1-19.
1.3.15 Master Dialing
Master Dialing, discussed previously, is another unique application for RS366 dialing for the
system when using an 8213 HSU RS366 dialing port to dial for any other HSU card in the
system. A different command string is used to make these changes.
The command string is: [escape character] [35] [slot number] [port number], where “slot
number is the user card (1-8) and “port number” is the port in that slot to which subsequent
dialing commands should be applied.
The command: *3511, would indicate that the next series of commands would apply to port
#1 of the HSU card in slot U1.
Once a Master Dialing command is issued for HSU 821360 RS366 dialing ports, all further
dialing commands on this port will be applied to the new slot and port designated by the
Master Dialing command.
To return the RS366 to its normal position, the user can apply the special value of 0 (zero).
The command, *3500, tells the RS366 dialing to return to its home port. Table 1-19 shows the
possible modes of RS366 dialing, and command structures.
Table 1-19. Field Values for Command Strings
Basic Dialing
Field #1 Field #2 Field #3 Field #4 Field #5
[escape char] [00-31]
Channelization [service type] [call type] [number to dial]
Optional
Call Profile Loading
[escape char] [8] [call profile #] [number to dial]
and/or [initiate
action] Optional
Loopback Management
[escape char] [70-73]
Call Profile Change
[escape char] [64] [Parameter #] [Parameter val]
Master Dialing
[escape char] [35] [User slot#] [Hsu port #]