Zhone Technologies 900 - Manual (Page 17)

Data Cards IMACS System Release 5.1.6 1-5
HSU Card HSU Cards
1.2.5.1 HSU-T V35 Card Jumper/Switch Settings
The HSU-T V35 Card must be set either to U.S. or European configuration by moving a
jumper located on JP3. Figure 1-3 shows this jumper. Setting the jumper on the left two pins
establishes the U.S. voltage configuration. Setting it on the right two pins establishes the
European voltage. This setting should match the configuration of your particular chassis, or
the card will not operate properly. The factory default setting is US.
Figure 1-3. HSU-T V35 Card
1.2.5.2 Installing the HSU-T V35 Card
Install the HSU-T V35 Card into any user card slots. These slots are U1 to U8 on the two-sided
chassis and front-loading chassis with power supplies on top, or P1 to P4 and W1 to W4 on
the front-loading chassis with power supplies on the side.
HSU-T
530/35
P
1
P
2
US/Euro
Jumper