Zhone Technologies 900 - Manual (Page 49)

Data Cards IMACS System Release 5.1.6 1-37
HSU Card HSU Card User Screens and Settings
1.3.6 Broadcast Connection Status Screen
WHen the main ISDN call is placed, the system will attempt to establish connection with all
of the numbers on the Broadcast screen. The Broadcast screen allows the user to monitor or
change the status of each broadcast phone number on the list. Figure 1-20 shows how the
example used in the previous section will look after the call is placed. In this example, the call
to 415-731-6545 was “Not Connected” while the call to 415-940-7710 was “Connected.”
If the user highlights the “Not Connected” telephone number on the list and uses the
“Connect” command, the ISDN card will attempt to place the call again. The status of the call
will change to “Connecting.” When the call is completed the status will change to show
“Connected.”
To disconnect one of the Broadcast phones prior to the disconnect of the main call, the user
highlights the number and uses the “Disconnect” command. The system will prompt you with
a yes/no message before action is taken. When disconnected, the call status will change to
“Not Connected.”
Figure 1-20. Call Profile Broadcast Screen
Table 1-13. Call Profile Broadcast Screen Actions
Action Function
Connected
Connect | Disconnect | Refresh | Main