Printronix N7000 H-Series Cartridge Ribbon Printer - Manual (Page 111)

Epson FX Emulation
111
Printer Protocol
For the Hanzi LP+ printer, refer to the the LQ-1600K Programmer’s
Reference Manual and OKI Programmer’s Reference Manual for details.
CPI/LPI Select
This parameter lets you specify the characters per inch (cpi) and lines per
inch (lpi) values. For the Hanzi LP+ printer, if LQ1600K is selected, the default
values of Select CPI, Select LPI, and DBCS CPI are 10 cpi, 6 lpi, and 6.7 cpi.
If OKI is selected, the default values of Select CPI, Select LPI, and DBCS CPI
are 10 cpi, 6 lpi, and Default.
Host Command
• Ignore All . When set to Enable, this function ignores all host commands.
The default is Disable.
• Ignore CPI . When set to Enable and if LQ1600K emulation is selected,
this function ignores the CPI selection commands ESC M, ESC P, and
ESC g. If OKI emulation is selected, this function ignores the CPI
selection commands ESC N, ESC H, ESC B, and ESC E. The default is
Disable.
• Ignore LPI . When set to Enable and if LQ1600K emulation is selected,
this function ignores the LPI selection commands ESC 2 and ESC 0. If
OKI emulation is selected, this function ignores the LPI selection
commands ESC 6 and ESC 8. The default is Disable.
• Ignore Unidir . When set to Enable, all unidirectional commands sent by
the host are ignored by the printer. The default is Enable.
Font Attributes
Typeface
This parameter allows you to select the typeface for printing in the emulation.
• LQ . Default value for Hanzi Big5 and the Hanzi GB printer with OKI
selected.
• Near LQ . Default value for Hanzi GB printer with LQ1600K selected.
• Normal .
• Hi-Speed
• Super Hi-Speed
• Ultra Hi-Speed
Styling Type
• SONG . Only for Hanzi GB printer.
• MING . Only for Hanzi Big5 printer.
LinePrinter+ Emulation (N7000 H-Series)