Select lpi, P-series sfcc, Ribbon end point – Printronix N7000 H-Series Cartridge Ribbon Printer User Manual
Page 62: Save config, Power up config, Graphics spd-up
62
Chapter
4
Main Menu
Select LPI
This parameter allows you to specify the lines per inch (lpi) values.
The options are 6.0, 8.0, and 10.3 LPI. The factory default is 6.0 LPI.
NOTE:
10.3 LPI is available on N7000 STD firmware only.
P-Series SFCC
This parameter allows you to select which ASCII codes will function as the
Special Function Control Code (SFCC) command delimiter.
P-Series codes can use hex 00 through hex 7F. Options include the following:
•
SOH (hex 01)
(the default)
•
ESC (hex 1B)
•
ETX (hex 03)
•
CIRCUMFLEX (hex 5E)
– also called caret (^)
•
TILDE (hex 7E)
– (~)
NOTE:
SOH, ETX, and ESC are non-printables. The characters (^) and (~)
are printable; however, do not use them as printables in the host data
stream if either is chosen as a delimiter because print errors will
occur.
NOTE:
Available for N7000 STD firmware only.
Ribbon End Point
This parameter adjusts the point at which the system will declare the ribbon
as being expended. The life count will always be from 100% to 0%, but if a
darker setting is selected 0% will be reached more quickly. If a lighter setting
is selected, the system will extend the time it takes to reach 0%.
Save Config
This option allows you to save up to eight configurations to meet different print
job requirements. This eliminates the need to change the parameter settings
for each new job. The configurations are stored in memory and will not be lost
if you turn off the printer. If the Protect Configs. parameter is enabled, the new
configuration will not be saved unless the existing configuration has been
deleted first. The factory default configuration cannot be changed. See
“Saving Your New Configuration” on page 50 for details.
Power Up Config
This option allows you to specify which of the nine configurations (Factory or
1-8) will be the power-up configuration.
Graphics Spd-Up
This menu is used to increase (speed up) graphic printing speed by turning on
Enhanced/Turbo/Match Typeface mode. See “Graphics Spd Up” in the
LQ1600K Programmer’s Reference manual.
NOTE:
Available for H-Series firmware only.