Set sharing, Shuttle timeout, Slow paper slew – Printronix N7000 H-Series Cartridge Ribbon Printer User Manual
Page 151: Alarm
IGP/VGL Submenu
151
•
Print File List
. Prints a summary of the files stored in flash memory and
several statistics on File System usage.
IMPORTANT
Do not turn the printer off until it has completely rebooted and is either
back online or offline.
Set Sharing
This option allows character sets to be shared between the active LP+
protocol and the active IGP emulation.
Changing characters sets in LP+ causes the active IGP to change to the
same character set if the selected set exists in IGP. If the active IGP has no
access to the selected set, no changes are made. Selecting a new character
set in the active IGP causes the LP+ to change to the same character set if
the selected character set exists in the active LP+ protocol. Not all sets are
shared between emulations in the Standard group of character sets. As a
result, selecting a set in the Standard group of LP+ or IGP emulation may or
may not cause the other emulation to have the same set.
NOTE:
The Set Sharing front panel option has no effect on the LP+ builds.
The option only applies to the builds with IGP.
Shuttle Timeout
The amount of time the shuttle continues moving after no data is received. If
your host is slow, setting the number to a higher value will prevent the printer
from spending time shuttling up and down between data bursts.
Slow Paper Slew
•
Disable
(default). The paper will slew and stack paper at maximum
speed.
•
Enable
. Causes the paper to stack at a slower rate. This ensures that
certain forms will stack neatly.
Alarm
•
On
(default). An audible alarm sounds (3 beeps) when a fault occurs,
such as a paper jam.
•
Cont. Beep
. A continuous audible alarm sounds when a fault occurs,
which can be stopped by pressing CLEAR.
•
Off
. No audible alarm will sound.
ADVANCED USER