Printronix N7000 H-Series Cartridge Ribbon Printer - Manual (Page 60)

60
Chapter 4 Main Menu
QUICK SETUP Menu Definitions
Host Interface
The Host Interface menu enables you to select and configure interfaces
between the printer and your host computer.
Ethernet Address
• IP Address . A numeric address such as 123.45.61.23 which identifies a
printer or server in a LAN or WAN.
• Subnet Mask . A binary value used to divide IP networks into smaller
subnetworks or subnets. This mask is used to help determine whether IP
packets need to be forwarded to other subnets.
• Gateway Address . A gateway address is the IP address of a hardware
device (gateway) that translates data between two incompatible
networks, which can include protocol translation.
• MAC Address . This menu item is the Manufacturer’s Assigned Number,
and is unique for each printer. It is read-only.
• DHCP . You can enable/disable the DHCP protocol using this option, but
consult your administrator for the appropriate setting.
ZTP DataTime
This option sets the pause time in the data stream that the ZTP requires
before moving the form to the tear bar once a print job is completed. The
values range from .5 to 15 seconds. The default is .5 seconds.
ZTP WaitTime
This option sets the minimum amount of time that the form stays at the tear
bar. This allows you time to remove the form before the form is retracted to
print the next form. The adjustable values range from 1 to 10 seconds in
increments of 1 second. The default value is 2 seconds.
ZTP TearDist
This option sets the tear off distance from the current print position to the tear
bar. Adjustable values in increments of 1/144th of an inch range from 200 to
2880. The up and down arrows adjust the display value. When you press the
Enter key, the selected value is stored and a scale is printed to indicate the
current tear off position. The default value is 1060.
NOTE: When a new value is selected, the printer will lose the current print
position. You must reset the top of form to automatically save the new
value.