Printronix N7000 H-Series Cartridge Ribbon Printer - Manual (Page 234)

234
Chapter 7 Diagnosing Problems
ERROR: WRONG
OEM No The SPX inserted in the
debug port is not intended
for this model printer or this
OEM. Contact your authorized service
representative.
1
ERROR: WRONG
PRINTER TYPE No The SPX inserted in the
debug port is not intended
for this model printer or this
OEM. Contact your authorized service
representative.
1
ETHERNET
DETECTED N/A Status message indicating
that the Network Interface
Card has established
connection. No action is required.
ETHERNET
INITIALIZING No Status message: the internal
Network Interface Card is
processing the boot
procedure. (May occur with
older versions of microcode.) No action is required.
H00: PCI SLOT ?
See User Manual No The controller board is not
communicating with a PCI
card. This could indicate a
bad PCI card, poor
connection, or problem in
the PCI bus. Contact your authorized service
representative.
1
H01: PCI J12
See User Manual No The controller board is not
communicating with the PCI
card in PCI slot J12. This
could indicate a bad PCI
card, poor connection, or
problem in the PCI bus. Contact your authorized service
representative. 1
H02: PCI J13
See User Manual No The controller board is not
communicating with the PCI
card in PCI slot J13. This
could indicate a bad PCI
card, poor connection, or
problem in the PCI bus. Contact your authorized service
representative.
1
Table 13. N7000 H-Series Fault Messages Troubleshooting
Displayed Message
Can User
Correct?
Explanation Solution