Printronix N7000 H-Series Cartridge Ribbon Printer - Manual (Page 187)

N7000 STD ASCII Printers Fault Messages
187
E04A ISI NO TRA
See User Manual Yes An illegal or unsupported
instruction was attempted
in the application
program. 1. Cycle Power. Run the print job
again. If the message appears,
load the latest emulation
software.
2. Cycle power. Run the print job
again. If the message appears,
record the display message
and send it to your next higher
support facility.
E04B ISI DIRECT
See User Manual Yes An illegal or unsupported
instruction was attempted
in the application
program. 1. Cycle Power. Run the print job
again. If the message appears,
load the latest emulation
software.
2. Cycle power. Run the print job
again. If the message appears,
record the display message
and send it to your next higher
support facility.
E04C ISI PROTEC
See User Manual Yes An illegal or unsupported
instruction was attempted
in the application
program. 1. Cycle Power. Run the print job
again. If the message appears,
load the latest emulation
software.
2. Cycle power. Run the print job
again. If the message appears,
record the display message
and send it to your next higher
support facility.
E06 NOT ALIGNED
See User Manual Yes An illegal or unsupported
instruction was attempted
in the application
program. 1. Cycle Power. Run the print job
again. If the message appears,
load the latest emulation
software.
2. Cycle power. Run the print job
again. If the message appears,
record the display message
and send it to your next higher
support facility.
E07 ILLEGAL INS
See User Manual Yes An illegal or unsupported
instruction was attempted
in the application
program. 1. Cycle Power. Run the print job
again. If the message appears,
load the latest emulation
software.
2. Cycle power. Run the print job
again. If the message appears,
record the display message
and send it to your next higher
support facility.
Table 12. N7000 STD ASCII LCD Fault Messages Troubleshooting
Displayed Message
Can User
Correct?
Explanation Solution