Printronix N7000 H-Series Cartridge Ribbon Printer - Manual (Page 200)

200
Chapter 7 Diagnosing Problems
PAP ILLGL ST* No Paper Illegal State.
Firmware error on
controller board. Contact your authorized service
representative.
1
PAP INCMPL ENER* No Paper Incompletely
Energized. Firmware
error on controller board. Contact your authorized service
representative. 1
PAP INVLD CMD* No Paper Invalid Command.
Firmware error on
controller board. Contact your authorized service
representative. 1
PAP INVLD PARM* No Paper Invalid Parameter.
Firmware error on
controller board. Contact your authorized service
representative. 1
PAP NOT SCHED* No Paper Not Scheduled.
The paper feed process
is not scheduling on the
controller board, and the
printer cannot feed paper. Contact your authorized service
representative. 1
PAP NT AT SPEED* No Paper Not At Speed.
Firmware error on
controller board. Contact your authorized service
representative. 1
PAP UNEXP INT* No Paper Unexpected
Interrupt. Firmware error
on controller board. Contact your authorized service
representative. 1
PARITY ERROR Yes The printed output may
contain a random ?
(question mark)
characters. Check your printer serial interface
parameter settings; if necessary,
adjust them so that they match the
settings of the attached host.
PLAT INV CMD* No Platen Invalid Command.
Firmware error on
controller board. Contact your authorized service
representative. 1
PLAT INV PARM* No Platen Invalid Parameter.
Firmware error on
controller board. Contact your authorized service
representative. 1
PLAT INV STATE* No Platen Invalid State.
Firmware error on
controller board. Contact your authorized service
representative. 1
PLEASE WAIT...
RESET IN
PROGRESS
N/A Status message: the
printer finished loading
the program into flash
memory and is
automatically resetting
itself. No action is required.
Table 12. N7000 STD ASCII LCD Fault Messages Troubleshooting
Displayed Message
Can User
Correct?
Explanation Solution