Printronix N7000 H-Series Cartridge Ribbon Printer User Manual
Page 199
N7000 STD ASCII Printers Fault Messages
199
LOADING PROGRAM
FROM PORT XX%
No
Status message: the new
emulation program is
loading into printer RAM.
XX% indicates how much
of the program has
loaded.
No action is required.
LOADING PROGRAM
INTO FLASH
No
The printer has deleted
the previous program
from flash memory and is
loading the new program
into flash memory.
No action is required.
NEW SPX DETECTED
PRESS ENTER
No
The printer detects an
SPX installed at the
debug port and the SPX
is valid for the printer.
Contact your authorized service
representative.
1
NON VOLATILE
MEMORY FAILED
No
Large emulations reduce
the amount of space
available for saving
configurations, which
means that sometimes
fewer than eight
configurations can be
saved.
Contact your authorized service
representative.
1
ON LINE
N/A
Printer state message:
printer is online and in
communication with host.
No action is required.
PAP BAD TABLE*
No
Paper Bad Table. The
paper feed process on
the controller board has a
corrupted table.
Contact your authorized service
representative.
1
PAP BSY TOO LNG*
No
Paper Busy Too Long.
Firmware error on
controller board.
Contact your authorized service
representative.
1
PAP FD DRVR CIR*
See Manual
No
Paper Feed Driver
Circuit. The paper feed
driver circuit on the
controller board is
drawing too much
current.
Contact your authorized service
representative.
1
PAP FIFO OVERFL*
No
Paper First In First Out
Overflow. Firmware error
on controller board.
Contact your authorized service
representative.
1
PAP FIFO UNDRFL*
No
Paper First In First Out
Underflow. Firmware
error on controller board.
Contact your authorized service
representative.
1
Table 12. N7000 STD ASCII LCD Fault Messages Troubleshooting
Displayed Message
Can User
Correct?
Explanation
Solution