Printronix N7000 H-Series Cartridge Ribbon Printer - Manual (Page 195)

N7000 STD ASCII Printers Fault Messages
195
ERROR: PROGRAM
NEEDS MORE DRAM No The printer requires more
DRAM to run the
downloaded program. Contact your authorized service
representative.
1
ERROR: PROGRAM
NEEDS MORE FLASH No The printer requires more
flash memory to run the
downloaded program Contact your authorized service
representative. 1
ERROR: PROGRAM
NOT COMPATIBLE Yes The printer is not
compatible with the
downloaded program. Use the correct emulation software
options(s) for this printer model.
ERROR: PROGRAM
NOT VALID Yes The printer does not see
a program in flash
memory. There is no program in printer
memory. Download the emulation.
ERROR: SECURITY
KEY NOT DETECTED No The security key is not
present or failed. Contact your authorized service
representative. 1
ERROR: SHORT AT
ADDRESS XXXX No Hardware failure in
SDRAM or controller
circuitry. Contact your authorized service
representative.
1
ERROR: WRITING TO
FLASH No Hardware or software
fault in flash memory. Contact your authorized service
representative.
1
ERROR: WRONG
CHECKSUM No The printer received the
complete program but the
checksum did not match.
The data may have been
corrupted during
downloading. Contact your authorized service
representative.
1
ERROR: WRONG
OEM No The SPX inserted in the
debug port is not
intended for this model
printer or this OEM. Contact your authorized service
representative. 1
ERROR: WRONG
PRINTER TYPE No The SPX inserted in the
debug port is not
intended for this model
printer or this OEM. Contact your authorized service
representative. 1
ETHERNET
DETECTED N/A Status message
indicating that the
Network Interface Card
has established
connection. No action is required.
Table 12. N7000 STD ASCII LCD Fault Messages Troubleshooting
Displayed Message
Can User
Correct?
Explanation Solution