Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1895 - Manual (Page 16)

3. Electrical Installation
16 PNEG-1895 V2 Electronic Distributor Control
Electric Motor Connections at Control Panel
Connect the motor wiring to the terminals on the Variable Frequency Drive (VFD) in the control panel
as shown in
Figure 3H . Please note that the U-V-W order of the wires is not configured as labeled on
the VFD. Motor wiring should be kept as far away from sensor wiring terminal blocks as the installation
configuration permits.
Figure 3H Control Panel Wiring from Motor Electrical Connections
Ref # Description
A Ground Terminal Block
B Wire U
C Wire W
D Wire V
E Ground Wire
A
B
E
C
D