Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1895 - Manual (Page 18)

3. Electrical Installation
18 PNEG-1895 V2 Electronic Distributor Control
Power Supply Wiring to Control Panel Electrical Connections
NOTE: Ensure the power supply voltage source is OFF before installation.
Install power supply cable through the control panel using suitable hardware as shown in Figure 3J .
Connect the power supply hot wires (B) to the control panel circuit breakers (C) as shown in Figure 3J .
Connect the power supply ground wire (D) as shown in Figure 3J to the ground terminal block as shown
in Figure 3H on Page 16 .
Figure 3J Control Panel Wiring from Motor Electrical Connections
Ref # Description
A Power Cable Hardware
B Hot Wires
C Control Panel Circuit Breakers
D Power Supply Ground Wire
A
B C
D