Electrical installation – Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1895 User Manual
Page 9
Advertising
3. Electrical Installation
PNEG-1895 V2 Electronic Distributor Control
9
Control Panel Cable to Distributor Fitting Connections
Conduit for motor wiring should be run out of enclosure (DEC0005) (A) to the panel installed at ground
level. Conduit for sensor wiring should be run from enclosure (DEC0005) (A) to panel installed at ground
level. Appropriate fittings for conduit selection must be used at all connections.
Figure 3B Cable Fitting Connections to Distributor Enclosure
Ref #
Part#
Description
A
DEC0005
Enclosure
B
DEC0026-XXX
Sensor Cable
B
DEC0025-XXX
VFD Cable
NOTE: “XXX” represents the length of the cable.
A
B
B
Advertising