Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1895 - Manual (Page 46)

6. Retrofit Installation
46 PNEG-1895 V2 Electronic Distributor Control
Encoder and Bracket Installation
Install the encoder (DEC0106) (A) to the encoder mounting bracket (DEC0016) (B) using the three (3)
#10-32 bolts (S-10167) (D) and #10 washers (S-7223) (C) as shown in
Figure 6G .
Tighten the encoder collar set screw (E) as shown in Figure 6H on Page 47 to 8 in-lbs.
Install the encoder mounting bracket (DEC0016) (B) to the proximity sensor bracket (DEC0006) (H) using
the 1/4"-20 x 3/4" HHCS bolt (S-1429) (I), 1/4" washer (S-2126) (J) and 1/4"-20 nylock nut (S-7025) (K) as
shown in
Figure 6I on Page 48 .
Figure 6G Encoder to Mounting Bracket
Ref # Part # Description
A DEC0106 Encoder
B DEC0016 Encoder Mounting Bracket
C S-7223 #10 Washer
D S-10167 #10-32 Bolt