Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1895 - Manual (Page 41)

6. Retrofit Installation
PNEG-1895 V2 Electronic Distributor Control 41
Electronic Distributor Enclosure Installation
Install the enclosure (DEC0005) to the distributor (C) using four (4) 3/8 bolts (S-7469) (B) and nylock nuts
(S-7383) (A).
(See Figure 6B.) Note the orientation of the enclosure; the side with the two (2) large holes
must face away from back wall of distributor. Controller will not work if installed backwards.
Figure 6B Electronic Distributor Enclosure
Ref # Part # Description
A S-7383 3/8" Nylock Nut
B S-7469 3/8" Bolt
C Distributor