Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1895 - Manual (Page 40)

40 PNEG-1895 V2 Electronic Distributor Control
6. Retrofit Installation
Electronic Distributor Control Shaft Installation
Install the shaft (DEC0009) (A) to the distributor shaft (D) using two (2) roll pins (S-9288) (B). NOTE: Flag
extension (C) should be installed in line with the spout to ensure proper alignment with the sensor.
(See Figure 6A.)
Figure 6A Electronic Distributor Control Shaft
Ref # Part # Description
A DEC0009 Shaft
B S-9288 Roll Pin
C Flag Extension
D Distributor Shaft
E Spout