Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1895 - Manual (Page 51)

6. Retrofit Installation
PNEG-1895 V2 Electronic Distributor Control 51
Control Motor Installation
Install the motor (DEC0015) (A) to the motor mounting bracket (DEC0003) (F) using two (2) 1/4"-20 x 1"
HHCS bolts (S-6998), four (4) 1/4" washers (S-2126) (D) and two (2) 1/4"-20 nylock nuts (S-7025) (C) as
shown in
Figure 6M .
Install second motor mounting bracket (DEC0021) (B) to the enclosure (DEC0005) using two (2)
1/4"-20 x 3/4" HHCS bolts (S-1429) (E), 1/4" washers (S-2126) (D) and 1/4"-20 nylock nuts (S-7025) (C).
Then install the motor to the motor mounting bracket (DEC0021) (B) using two (2) 1/4"-20 x 1" HHCS
bolts (S-6998), four (4) 1/4" washers (S-2126) (D) and two (2) 1/4"-20 nylock nuts (S-7025) (C) as shown
in
Figure 6M .
Figure 6M Control Motor Installation
Ref # Part # Description
A DEC0015 Motor
B DEC0021 Motor Mounting Bracket - Short
C S-7025 1/4"-20 Nylock Nut
D S-2126 1/4" Washers
E S-1429 1/4"-20 x 1" HHCS Bolt
F DEC0003 Motor Mounting Bracket
G DEC0011 Key