YSI TruLab 1320P - Manual (Page 72)

Settings TruLab pH/ISE 1320
72
ba76157e01 03/2014
9.1.4 Settings for ORP measurements
The settings for ORP measurements are made in the menu for calibration and
measurement settings of the pH/ORP measurement. To open the settings, dis-
play the required measured parameter in the measured value display and
press the <MENU/ENTER> key. After completing the settings, switch to the
measured value display with <M>.
In the following table, only those settings are listed that influence the ORP mea-
surement.
Default settings are printed in bold.
Menu item Possible
setting Description
Man. temperature -25 ... +25 ...
+130 °C Entry of the manually determined
temperature. For measurements
without temperature sensor only.
Resolution mV 0.1
1 Resolution of the mV display
Reset - Resets all sensor settings to the
delivery condition (see section 9.4.1
R
ESETTING THE MEASUREMENT SET -
TINGS
, page 76).