Datamax-O'Neil Performance series User Guide - Manual (Page 116)

5 | Cleaning and Maintenance
Performance Series User’s Guide 136
1. Remove the media and ribbon.
2. With a can of compressed air, spray both (2) sensors to remove dust and debris.
3. Repeat as necessary.
Cleaning the Paper Low Sensor
The Paper Low Sensor should be cleaned whenever necessary.
1. Remove the media and ribbon.
2. Wipe the sensor with the clean, lint-free cloth.
3. Repeat as necessary.
Cleaning the Printhead
For optimum performance, the printhead should be routinely cleaned with factory-
approved cleaning supplies. When using the cleaning pen, follow the instructions located
on the packaging.
Cleaning Cards
Cleaning cards are effective at removing many common adhesives and contaminants
from printheads.
1. Remove the media and ribbon.
2. Insert the cleaning card under the printhead.
3. Select Menu / Tools / Maintenance / Cleaning and then select Clean Now.
4. Slide the cleaning card in and out to scrub the printhead.
5. Repeat as necessary.
Cleaning the Cutter
The cutter should be routinely cleaned to prevent jams.
1. Release the cutter mechanism from its magnetic hold.
2. Using a can of compressed air, gently blow out the debris from the cutter area.
Warning: To prevent injury, the cutter should never be disassembled for any reason.