Datamax-O'Neil Performance series User Guide User Manual
Page 59
Connections and Setup | 3
51
Performance Series User’s Guide
Installing Cutter and Tray
Warning:
To prevent serious injury, never place a finger or object other than media near
the cutter mechanism.
Caution:
Never cut paper or media in an area where adhesives exist. Doing so will
damage the cutter and void the manufacturer’s warranty.
Caution:
The media cover will not close with both the cutter and present sensor installed
at the same time for those printers with a present sensor installed in the cover..
Caution:
The printer must be powered off and disconnected from AC utility power prior
to the cutter installation.
The cutter and cutting tray are available options that must be installed after receiving the
printer.
Cutter
Perform the following procedure to install the cutter.
Note:
The printer and the cutter tray must be on the same level surface.
1. Power off the printer and disconnect it from utility power.
2. Remove the lower cover from the printer.
Figure: 3 - 37 Lower Cover
Note:
The printer cover can be removed by carefully pulling the bottom of the cover.