Datamax-O'Neil Performance series User Guide - Manual (Page 71)

Menu System | 4
93 Performance Series User’s Guide
Operator Action Area
Information about the current printer action will be displayed in this area. For example,
“Printing 1 of 3” might be displayed when printing the first of three labels for a print job.
Date / Time
The time and date may be toggled on by pressing the upper right corner of the display.
After pressing the blank area, the current date and time will be displayed on the screen.
Once the home button is pressed, a screen will appear asking the user if the date and
time will be displayed. Select the green Accept button to display the time or the red
Reject button to cancel.
Fault Information Area
Warnings and faults will be displayed in this area. Once the fault has been corrected, the
message will disappear.
Connected Devices
The symbol for devices connected to the USB host will be presented in this area.
Mode Indicators
The printer will display modes that have been activated. If options have been installed
but not enabled, they will not appear in this area of the display.
Information Button
By selecting the information button from the task bar, the following information can be
accessed. Select the Print button in the taskbar to print the information. Not all of the
information listed below is available for every printer.
• System Info
• Settings Report
• Network Report
• Extended Status
• Serial Report
• GPIO Report
• Fonts Report
Note: Selecting the up or down arrow will display additional information.