Datamax-O'Neil Performance series User Guide User Manual
Page 61
Connections and Setup | 3
53
Performance Series User’s Guide
5. Rotate the cutter until it magnetically locks into place.
6. Activate the cutter option in the Options menu by selecting Menu > Advanced >
Printer > Options > Cutter.
Note:
Feed a label through the printer and observe the cut distance to ensure it cuts on
the gap. If it cuts on the label, adjust your Cut Distance Adjust settings in the
Adjustments menu. Select Menu > Advanced > Adjustments > Cut Distance Adjust.
Note:
A negative value moves the cut line toward the current label being printed. A
positive value moves the cut line toward the next label to be printed.
Cutter Tray
The cutter tray collects labels and media after they have been cut. The tray may be
installed before or after the installation of the cutter.
1. Place the tray mounting hooks into the baseplate slots.
Note:
For a clearer illustration, the cutter has been removed from the illustration below.
Figure: 3 - 40 Cutter Tray Installation
Mounting Hooks
Baseplate
Slots