Datamax-O'Neil Performance series User Guide - Manual (Page 43)

Connections and Setup | 3
35 Performance Series User’s Guide
5. Route the ribbon under the printhead, over the ribbon shield and clockwise around
the ribbon rewinder hub.
Figure: 3 - 21 Route to Ribbon Rewinder Hub
Note: Roll the ribbon around the ribbon rewinder hub at least five (5) times to ensure it
will stay in position.
6. Ensure the thermal transfer option is selected in the control panel.
7. Set the thermal transfer option to CSI or CSO depending on the ribbon type.
Note: See the menu section for more information about the printer settings.