Datamax-O'Neil Performance series User Guide - Manual (Page 50)

3 | Connections and Setup
Performance Series User’s Guide 42
Note: If the rewinder is enabled, the Auto Present Distance set, and the printer in
Prompt or Applicator mode, then the actual printer present distance will be set to work
with the peel mechanism.
Top-of-Form Sensor
This printer is designed to use several types of media. The top-of-form sensor can read
media characteristics from the center to the left inside edge (viewing from the front of the
printer). Setting the top-of-form sensor to read specific media characteristics is done in
the control panel.
Media Types Supported
There are five paper types that are supported. These include gap, mark on top, mark on
bottom, notch and continuous.
The following are illustrations of the types of supported media but not every supported
media is illustrated. Please contact your reseller for assistance in selecting the
appropriate media for the printer.
Figure: 3 - 25 Gap Example