Datamax-O'Neil Performance series User Guide - Manual (Page 91)

Menu System | 4
113 Performance Series User’s Guide
Note: *These values may vary depending on the printer model.
Communications
Select Communications to change the communications settings.
a. Ethernet
The following Ethernet communications settings may be adjusted:
Table 12: Ethernet Communications Settings
Once the data has been entered, select the Home button and then select the green
Accept button to save the changes which will require a printer reboot.
If necessary, the user may return to the default settings by selecting General > Reset
Defaults > Ethernet.
b. Wireless
The following wireless settings may be set for printers with the wireless option installed:
Table 13: Wireless Settings
Ribbon Low Diameter 1.0 to 2.0 in. 1.5 in.
Functions Values Actions Default
DHCP Enabled
Disabled
Enabled
IP Address If DHCP is disabled, enter the
appropriate value 0.0.0.0
Subnet Mask If DHCP is disabled, enter the
appropriate value 0.0.0.0
Gateway If DHCP is disabled, enter the
appropriate value 0.0.0.0
Functions Values Actions Default
Wireless Enable Enabled
Disabled
Enabled
SSID Enter the appropriate SSID value 0.0.0.0
Wireless DHCP Enabled
Disabled
Enabled
IP Address Enter the appropriate value 0.0.0.0
Subnet Mask Enter the appropriate value 0.0.0.0
Media Settings Values Ranges Default