Datamax-O'Neil Performance series User Guide User Manual
Page 90
4 | Menu System
Performance Series User’s Guide
112
Table 10: Rewinder Settings
f. Set Defaults
The factory default settings for the printer setup can be reset. To reset to the default
settings, select Set Defaults. Confirm your selection by selecting the green Accept
button.
Note:
If the current custom settings have not been saved but will be needed again, be
sure to save them with the User Files utility from the Tools menu before resetting to
defaults.
Media
Select Media to change the print media settings.
Table 11: Media Settings
Rewinder Settings
Values
Ranges
Default
Rewinder Mode
Off
Clockwise
Counter Clockwise
Off
Rewinder Tension Adjust
-10 to 10
0
Media Settings
Values
Ranges
Default
Paper Sensor Type
Gap
Mark on Top
Mark on Bottom
Notch
Continuous
Gap
Paper Sensor Side
Outside
Inside
Outside
Ribbon Mode
Coated In
Coated Out
None
Coated In
Heat
1 to 30
5*
Heat Balance
1 to 10
8*
Head Pressure (Suggested)
1 to 10
7*
Rewinder Tension
1 to 20
12*
Ribbon Tension Front
1 to 30
20*
Ribbon Tension Rear
1 to 20
15*