Datamax-O'Neil Performance series User Guide User Manual
Page 118
Advertising
6 | Maintenance
Performance Series User’s Guide
140
3. Insert a 3mm hex head wrench into the openings and loosen both (2) screws
securing the printhead to the printhead mechanism.
Note:
Both screws are spring-loaded and captured eliminating the need to remove them.
Note:
The printhead will drop down enabling access to both wiring connectors. The
p1115 has a single connector.
Figure: 6 - 2 Printhead Screws
Note:
There are two (2) view ports on the ribbon plate that enable the screws to be seen.
4. Carefully disconnect both connectors from the printhead.
Caution:
Always grasp the printhead from the sides to avoid damaging sensitive
electrical components.
Viewports
Openings
Screw
Advertising