Datamax-O'Neil Performance series User Guide User Manual
Page 93
Menu System | 4
115
Performance Series User’s Guide
To return to the default settings, select General > Reset Defaults > Serial.
d. General
Select from the following to change the General communications settings:
Services
The following services may be enabled or disabled:
•
Enable Network Time Protocol
•
Enable Webpages
•
Enable SSH (SSH-2 is supported)
•
Enable SNMP
•
SNMP Trap IP
•
Enable LPD
To print using the LPD service, connect from a host using the LPR port and the
queue name “lp”.
Table 15: Services
Webpages provide a printer configuration interface for the user. Users can view the
printer status, set printer parameters, print test labels and perform simple actions like
printer calibration and setting defaults.
To access the printer Webpages from a computer where the printer has been installed,
type the printer’s IP address into the Web browser URL field.
Note:
The printer must be connected to the Ethernet.
Protocol
None
Hardware
Software
Both
None
Services
Default
Enable Network Time Protocol Disabled
Enable Webpages
Enabled
Enable SSH
Enabled
Enable SNMP
Enabled
SNMP Trap IP
127.0.0.1
Enable LPD
Enabled
Functions
Values
Ranges
Default