Datamax-O'Neil Performance series User Guide User Manual
Page 119
Advertising
Maintenance | 6
141
Performance Series User’s Guide
Caution:
Exercise caution when disconnecting the printhead connections to avoid
damaging the printhead or the connectors.
Figure: 6 - 3 Printhead Connectors (p1115s, p1120n, p1125 & p1725)
5. Install the new printhead in the reverse order as it was disassembled from the
printer and tighten the hex head screws using a torque of 2.0 to 3.0 in. lbs (2.3 - 3.4
kgf cm).
Caution:
Do not over-tighten the printhead fasteners.
Note:
Ensure the alignment pins are centered in the alignment slots on the printhead.
Alignment Slots
Top
Fastener Locations
Advertising