7troubleshooting errors – Datamax-O'Neil Performance series User Guide User Manual
Page 125
153
Performance Series User’s Guide
7
Troubleshooting
Errors
The following errors may be displayed:
Note:
System errors are not caused by media mismatches but can be caused by a poor
label format.
Errors
Description
SYSTEM ERROR
Illegal label format or communications error
OUT OF RIBBON
Out of ribbon
OUT OF PAPER
Out of paper
CUTTER JAMMED
Cutter is jammed
REWINDER FULL
Rewinder is full
PRINTHEAD UNLATCHED
Printhead is unlatched
PRINTHEAD HOT
Printhead is critically hot
FPGA HARDWARE
Analog to digital converter hardware fault
NV RAM HARDWARE
Non-volatile memory hardware fault
PAPER SENSOR BLOCKED
Top-of-form sensor blocked or hardware fault
PAPER CALIBRATION
Could not calibrate media
NO TOP OF FORM FOUND
Could not find a gap or mark
RIBBON HARDWARE
Ribbon controller hardware fault
PRESENT SENSOR
Present Sensor hardware fault
AUTOLOAD SENSOR BLOCKED
Auto load sensor hardware fault
GPIO HARDWARE
GPIO hardware fault
MOTOR HOT
Motor is critically hot