Datamax-O'Neil Performance series User Guide User Manual
Page 34
3 | Connections and Setup
Performance Series User’s Guide
26
12. Rotate the latch lever counter-clockwise until the printhead mechanism is locked.
Figure: 3 - 11 Lock the Printhead Mechanism
Note:
If the media has been installed properly and read by the autoloading sensor, it
should automatically feed under the printhead once the printhead carriage assembly has
been latched and locked. If the media does not automatically load, unlatch the printhead
assembly and manually feed the media under the printhead. Upon locking the printhead,
it would be beneficial to both feed the media by selecting the Feed button on the main
menu to properly set the next label and perform a Paper Calibration.
13. Set the Top-of-Form sensor
Note:
Refer to the section called “Top-of-Form Sensor”. Setting the top-of-form sensor to
read specific media characteristics is done in the control panel.