Fairbanks FB2550 DAT SERIES DRIVER ACCESS TERMINAL - Manual (Page 107)

Section 5: Accessories
2/2013 107 51303 Rev. 1
6.3.4. RESETTING TO THE AXIS FACTORY DEFAULTS
Restoring the Factory Default Settings is used when the previous steps do not
resolve problems with the Camera Unit.
1. Disconnect the POWER CABLE
from the Camera unit.
2. Remove the two (2) Torx screws,
holding the camera into place with a
T20 ALLEN KEY .
3. Flip the camera over to reveal the
control components on the bottom.
4. Reconnect the Power Cable
.
– Wait approximately fifteen (15) seconds until the NET and PWR led lights are
orange.
5. Press and hold the RESET button for approximately thirty (30) seconds until
the NET led light flickers green, then release RESET button.
– Doing this resets the Factory Defaults.
6. Reassemble the Camera Unit and follow STEPS 1-16 from SECTION 11.2. and
11.2.1.
to complete the programming process.
TORX Screws
RESET NET PWR
SWITCH LED LED