Em-u432 thermal printer settings, continued, Settings for dip switch dsw2, Interface reset signals – Fairbanks FB2550 DAT SERIES DRIVER ACCESS TERMINAL User Manual
Page 74
Section 4: Input/ Output
2/2013
74
51303 Rev. 1
5.1.2. EM-U432 THERMAL PRINTER SETTINGS,
CONTINUED
SETTINGS FOR DIP SWITCH DSW2
SW
NO.
FUNCTION
ON
OFF
1
EU-T432
– 79.5mm paper-width model; 576
dots, 3.15”
Switch 1 –
On
Switch 2 –
OFF
2
3
Print Density Selection .
See
Print Density Selection
chart below.
4
5
Operation Mode Selection
See
Operation Mode Selection
chart below.
6 Factory
Use
7
I/F Pin 6 reset signal – 1
Enabled
Disabled
8
I/F Pin 6 reset signal – 2
Enabled
Disabled
LEVEL
PRINT DENSITY SELECTION
SWITCH NUMBER
3
4
1 Slightly
Light
ON
ON
2
Normal
OFF
OFF
3
Slightly Dark
ON
OFF
4
Dark
OFF
ON
OPERATION MODE SELECTION
SWITCH NUMBER
5
Hexadecimal Dump
ON
Normal
OFF
NOTES:
Changes in DIP Switch settings (excluding switches
2-7
and
2-8
Interface Reset
Signals
) are recognized only when the printer power is turned on, or when the
printer is reset by using the Interface.
Turning on the DIP Switches
2-7
and
2-8
while the printer power is turned on, the
printer may be reset, depending on the signal state.
DIP Switches should not ever be changed while the printer power is on.