Fairbanks FB2550 DAT SERIES DRIVER ACCESS TERMINAL - Manual (Page 93)

Section 4: Input/ Output
2/2013 93 51303 Rev. 1
5.8.3. CONTROLNET, CONTINUED
NETWORK STATUS
MODULE STATUS
LED STATE INDICATION
A and B OFF Not online / No power
Flashing Red (1 Hz) Incorrect node configuration, duplicate MAC ID etc.
Alternating Red/Green Self test of bus controller
Red Fatal event or faulty unit
A or B OFF Channel is disabled
Alternating Red/Green
Invalid link configuration
Flashing Green (1 Hz) Temporary errors (node self-corrects) or node is not
configured to go online.
Green Normal operation
Flashing Red (1 Hz) Media fault or no other nodes on the Network
STATE INDICATION
OFF No power
GREEN Operating in normal condition, controlled by a Scanner in RUN state.
FLASHING GREEN
(1 Hz) The module has not been configured or the Scanner is in the Idle state.
Red Unrecovrerable fault(s), EXCEPTION,
Flashing Red (1
Hz) Media fault or no other nodes on the Network
NO. DESCRIPTION
1 Network Status LED A
2 Module Status LED
3 Network Status LED B
4 ControlNet Connector A
5 ControlNet Connector B