Fairbanks FB2550 DAT SERIES DRIVER ACCESS TERMINAL - Manual (Page 144)

Appendix I: Fieldbus Interface Reference Data
2/2013 144 51303 Rev. 1
E. STATUS/COMMAND WORD BIT USAGE, CONTINUED
LOAD SETPOINT 2 WORD 1 BIT 6
Command: Load setpoint 2 for this scale.
Status:
Switches to 1 when command is executed returns to zero when
command is cleared.
LOAD CELL STATUS WORD 1 BITS 8,9,10,11,12
Command: Not applicable.
Status:
All cells are when the value is zero, else data indicates the number of
the failing or failed cell.
PRINT COMMAND: WORD 1 BIT 14
Command: Print scale ticket
Status:
Switches to 1 when the command is recognized and resets after the
print cycle is complete and the command bit is reset.
BEEP WORD 1 BIT 15
Command: Sound Instrument audible alarm.
Status:
Switches to 1 when command is executed, resets to 0 after the
command bit is reset.
DISPLAY MESSAGE WORD 2 BIT 0
Command: Display message on Instrument display. Message loaded from display
memory 1 to 3 lines.
Status: Switches to 1 when the command is received and the message is
displayed.
When scale operator operates any key, the message and bit are
cleared.
SCALE ABOVE MAXIMUM WEIGHT WORD 2 BIT 1
Command: Not applicable.
Status:
Bit is set when scale weight is at or above the programmed value.