Method 2, continued – Fairbanks FB2550 DAT SERIES DRIVER ACCESS TERMINAL User Manual
Page 58
Section 3: Configuration Menu
2/2013
58
51303 Rev. 1
4.4.4. METHOD 2, CONTINUED
When configuring an output data string, the
Fairbanks’ FB2550 DAT has seven (7)
commonly used pre-configured outputs.
8. Select the correct data string type.
Displayed below are the data string protocols*.
Fairbanks
<STX><A><B><C><GGGGGG><TTTTTT><CR>
Toledo
<STX><A><B><C><GGGGGG><TTTTTT><CR>
Cardinal
<CR><P><WWWWWW><M><SP><U><SP><G><SP><SP><ETX>
Weightronix
< ><M><WWWWWW>< ><U><CR><LF>
Condec
<STX><P><WWWWWW><U><G><M><CR>
DT7000 Anybus
<STX><SW0><SW1><SW2><UD><GW><TW>NW><SP1><SP2><FR><UD><CRC><XCH
>
SMA Protocol
<LF> <S> <R> <N> <M> <F> <XXXXXX.XXX> <UUU> <CR>
* See Appendix II: Data Output for further information.
NOTE :
In the images shown,
Configure COM1
was selected